烧录启动后串口日志如下：
android_image_load_by_partname: Can't find part: boot
Android image load failed
Android boot failed, error -1.
MMC error: The cmd index is 1, ret is -110
Card did not respond to voltage select!
mmc_init: -95, time 10
switch to partitions #0, OK
mmc0(part 0) is current device
Scanning mmc 0:3...
Found /extlinux/extlinux.conf
Get board-id node failed
Retrieving file: /extlinux/extlinux.conf.TRs112
** File not found /extlinux/extlinux.conf.TRs112 **
Error reading config file
SCRIPT FAILED: continuing...
MMC error: The cmd index is 1, ret is -110
Card did not respond to voltage select!
mmc_init: -95, time 9
** Bad device mmc 1 **
MMC error: The cmd index is 1, ret is -110
Card did not respond to voltage select!
mmc_init: -95, time 9
** Bad device mmc 1 **
Scanning mmc 0:3...
Found /extlinux/extlinux.conf
Get board-id node failed
Retrieving file: /extlinux/extlinux.conf.TRs112
** File not found /extlinux/extlinux.conf.TRs112 **
Error reading config file
SCRIPT FAILED: continuing...
starting USB...
Bus dwc3@ffd00000: Register 1000140 NbrPorts 1
Starting the controller
USB XHCI 1.10
scanning bus dwc3@ffd00000 for devices... 1 USB Device(s) found
scanning usb for storage devices... 0 Storage Device(s) found
Device 0: unknown device
EQOS_DMA_MODE_SWR stuckFAILED: 0rv1126_set_rgmii_speed can't get clk_mac_speed clock (ret=-61):
missing environment variable: pxeuuid
Retrieving file: /extlinux/pxelinux.cfg/01-10-dc-b6-90-53-6c
EQOS_DMA_MODE_SWR stuckFAILED: 0rv1126_set_rgmii_speed can't get clk_mac_speed clock (ret=-61):
Retrieving file: /extlinux/pxelinux.cfg/00000000
EQOS_DMA_MODE_SWR stuckFAILED: 0rv1126_set_rgmii_speed can't get clk_mac_speed clock (ret=-61):
Retrieving file: /extlinux/pxelinux.cfg/0000000
EQOS_DMA_MODE_SWR stuckFAILED: 0rv1126_set_rgmii_speed can't get clk_mac_speed clock (ret=-61):
Retrieving file: /extlinux/pxelinux.cfg/000000
EQOS_DMA_MODE_SWR stuckFAILED: 0rv1126_set_rgmii_speed can't get clk_mac_speed clock (ret=-61):
Retrieving file: /extlinux/pxelinux.cfg/00000
EQOS_DMA_MODE_SWR stuckFAILED: 0rv1126_set_rgmii_speed can't get clk_mac_speed clock (ret=-61):
Retrieving file: /extlinux/pxelinux.cfg/0000
EQOS_DMA_MODE_SWR stuckFAILED: 0rv1126_set_rgmii_speed can't get clk_mac_speed clock (ret=-61):
Retrieving file: /extlinux/pxelinux.cfg/000
EQOS_DMA_MODE_SWR stuckFAILED: 0rv1126_set_rgmii_speed can't get clk_mac_speed clock (ret=-61):
Retrieving file: /extlinux/pxelinux.cfg/00
EQOS_DMA_MODE_SWR stuckFAILED: 0rv1126_set_rgmii_speed can't get clk_mac_speed clock (ret=-61):
Retrieving file: /extlinux/pxelinux.cfg/0
EQOS_DMA_MODE_SWR stuckFAILED: 0rv1126_set_rgmii_speed can't get clk_mac_speed clock (ret=-61):
Retrieving file: /extlinux/pxelinux.cfg/default-arm-rockchip
EQOS_DMA_MODE_SWR stuckFAILED: 0rv1126_set_rgmii_speed can't get clk_mac_speed clock (ret=-61):
Retrieving file: /extlinux/pxelinux.cfg/default-arm
EQOS_DMA_MODE_SWR stuckFAILED: 0rv1126_set_rgmii_speed can't get clk_mac_speed clock (ret=-61):
Retrieving file: /extlinux/pxelinux.cfg/default
EQOS_DMA_MODE_SWR stuckFAILED: 0rv1126_set_rgmii_speed can't get clk_mac_speed clock (ret=-61):
Config file not found
EQOS_DMA_MODE_SWR stuckFAILED: 0rv1126_set_rgmii_speed can't get clk_mac_speed clock (ret=-61):
有没有人能告诉我哪里出错啊！！！！
作者: HQF 时间: 2021-7-21 17:47
已经好了，但是网络打不开了
root@debian10:/# ifconfig eth0 up
[ 87.356357] [dhd] CFG80211-ERROR) wl_cfg80211_netdev_notifier_call : wdev null. Do nothing
[ 87.357957] Generic PHY stmmac-0:00: attached PHY driver [Generic PHY] (mii_bus:phy_addr=stmmac-0:00, irq=POLL)
[ 87.369680] dwmac4: Master AXI performs any burst length
[ 87.369750] rk_gmac-dwmac ffc40000.ethernet eth0: No Safety Features support found
[ 87.369779] rk_gmac-dwmac ffc40000.ethernet eth0: IEEE root@debian10:/# 1588-2008 Advanced Timestamp supported
[ 87.370420] rk_gmac-dwmac ffc40000.ethernet eth0: registered PTP clock
[ 87.370953] [dhd] CFG80211-ERROR) wl_cfg80211_netdev_notifier_call : wdev null. Do nothing
[ 87.371127] [dhd] CFG80211-ERROR) wl_cfg80211_netdev_notifier_call : wdev null. Do nothing
[ 88.373328] rk_gmac-dwmac ffc40000.ethernet eth0: Link is Up - 100Mbps/Full - flow control rx/tx
[ 88.373416] [dhd] CFG80211-ERROR) wl_cfg80211_netdev_notifier_call : wdev null. Do nothing作者: 我是流氓我怕谁 时间: 2021-7-22 11:46
sudo dhclient eth0试下