Toybrick

标题: 3588配置bt1120输出不成功 [打印本页]

作者: lyc 时间: 2023-11-20 14:19
标题: 3588配置bt1120输出不成功
本帖最后由 lyc 于 2023-11-20 14:31 编辑

想使用vp0--HDMI显示文件系统内容的同时使用vp3--rgb配置bt1120显示摄像头采集图像，目前不能成功。kernel运行起来后一直打印dwhdmi-rockchip fdea0000.hdmi: use tmds mode
log显示出错：
[ 2.702796] [drm:rockchip_rgb_bind] *ERROR7
[ 3.397687] rockchip-drm display-subsystem: bound fd58c000.syscon:rgb (ops 0)
[ 3.398128] rockchip-drm display-subsystem: failed to parse loader memory 大神能不能帮忙看看我是哪里配置有问题，谢啦
1.rk3588-toybrick.dtsi文件
路径：edge/kernel/linux-5.10/arch/arm64/boot/dts/rockchip/rk3588-toybrick.dtsi
&vop {
      status = "okay";
};

&vop_mmu {
      status = "okay";
};

/* vp0 & vp1 splice for 8K output */
&vp0 {
      rockchip,plane-mask = <(1 << ROCKCHIP_VOP2_CLUSTER0 | 1 << ROCKCHIP_VOP2_ESMART0)>;
      rockchip,primary-plane = <ROCKCHIP_VOP2_ESMART0>;
};

&vp1 {
      rockchip,plane-mask = <(1 << ROCKCHIP_VOP2_CLUSTER1 | 1 << ROCKCHIP_VOP2_ESMART1)>;
      rockchip,primary-plane = <ROCKCHIP_VOP2_ESMART1>;
};

&vp2 {
      rockchip,plane-mask = <(1 << ROCKCHIP_VOP2_CLUSTER2 | 1 << ROCKCHIP_VOP2_ESMART2)>;
      rockchip,primary-plane = <ROCKCHIP_VOP2_ESMART2>;
};

&vp3 {
      rockchip,plane-mask = <(1 << ROCKCHIP_VOP2_CLUSTER3 | 1 << ROCKCHIP_VOP2_ESMART3)>;
      rockchip,primary-plane = <ROCKCHIP_VOP2_ESMART3>;
};

2.rk3588-toybrick-x0.dtsi文件路径：edge/kernel/linux-5.10/arch/arm64/boot/dts/rockchip/rk3588-toybrick-x0.dtsi
  （1）/ {
   hdmiin_dc: hdmiin-dc {
                     compatible = "rockchip,dummy-codec";
            #sound-dai-cells = <0>;
      };

   panel {
         status = "okay";
         compatible = "simple-panel";
         reset-gpios = <&gpio1 RK_PB2 GPIO_ACTIVE_LOW>;
         reset-delay-ms = <10>;

         bus-format = <MEDIA_BUS_FMT_YUYV8_1X16>;
            display-timings {
                     native-mode = <&timing1>;
                     timing1: timing1 {
                              clock-frequency = <74250000>;
                              hactive = <1920>;
                              vactive = <1080>;
                              hback-porch = <148>;
                              hfront-porch = <88>;
                              vback-porch = <36>;
                              vfront-porch = <4>;
                              hsync-len = <44>;
                              vsync-len = <5>;
                              hsync-active = <1>;
                              vsync-active = <1>;
                              de-active = <1>;
                              pixelclk-active = <1>;
                     };
            };
   port {
         panel_in_rgb: endpoint{
            remote-endpoint = <&rgb_out_panel>;
         };
      };
};
}

（2）
&hdmi1 {
      enable-gpios = <&gpio3 RK_PC7 GPIO_ACTIVE_HIGH>;
      status = "okay";
};

&hdmi1_in_vp0 {
      status = "okay";
};

&route_hdmi1 {
      status = "okay";
};

&hdptxphy_hdmi1 {
      status = "okay";
};

&display_subsystem {
      status = "okay";
};

&route_rgb {
status = "okay";
};

&rgb {
status = "okay";
pinctrl-names = "default";
      pinctrl-0 = <&bt1120_pins>;

ports {
      port@1 {
         reg = <1>;
         rgb_out_panel: endpoint {
            remote-endpoint = <&panel_in_rgb>;
         };
      };
};

};

&rgb_in_vp3 {
status = "okay";
};

3.rockchip_display.h
路径：edge/uboot/drivers/video/drm/rockchip_display.h
#define ROCKCHIP_OUT_MODE_BT1120       0
#define VOP_OUTPUT_IF_BT1120       BIT(1)

4.rockchip_rgb.c
路径：edge/uboot/drivers/video/drm/rockchip_rgb.c
函数：static int rockchip_rgb_connector_init(struct rockchip_connector *conn, struct display_state *state)
      case MEDIA_BUS_FMT_YUYV8_1X16:
      case MEDIA_BUS_FMT_YVYU8_1X16:
      case MEDIA_BUS_FMT_UYVY8_1X16:
      case MEDIA_BUS_FMT_VYUY8_1X16:
            conn_state->output_mode = ROCKCHIP_OUT_MODE_BT1120;
            conn_state->output_if = VOP_OUTPUT_IF_BT1120;
            break;

5.rockchip_vop.c
路径：edge/uboot/drivers/video/drm/rockchip_vop.c
函数：static int rockchip_vop_init(struct display_state *state)
      switch (conn_state->type) {
      case DRM_MODE_CONNECTOR_LVDS:
            VOP_CTRL_SET(vop, rgb_en, 1);
            VOP_CTRL_SET(vop, rgb_pin_pol, val);
            VOP_CTRL_SET(vop, rgb_dclk_pol, dclk_inv);
            VOP_CTRL_SET(vop, lvds_en, 1);
            VOP_CTRL_SET(vop, lvds_pin_pol, val);
            VOP_CTRL_SET(vop, lvds_dclk_pol, dclk_inv);
            if (!IS_ERR_OR_NULL(vop->grf))
                     VOP_GRF_SET(vop, grf_dclk_inv, dclk_inv);
            if (conn_state->bus_format == MEDIA_BUS_FMT_YUYV8_1X16) {
                     VOP_CTRL_SET(vop, bt1120_en, 1);
                     VOP_CTRL_SET(vop, bt1120_yc_swap, 1);
            }
            break;

6.rockchip_vop.h
路径：edge/uboot/drivers/video/drm/rockchip_vop.h
结构体：struct vop_ctrl {}
      struct vop_reg bt1120_yc_swap;
      struct vop_reg bt1120_en;

欢迎光临 Toybrick (https://t.rock-chips.com/)