|
|
本帖最后由 pikajian 于 2025-9-25 14:34 编辑
想要嘗試快速開機功能, 嘗試修改uboot 配置.
燒錄完後就無法進入系統也無法再次燒錄固件了.
DDR efc8cb38c0 wesley.yao 25/02/05-19:44:42,fwver: v1.14
DDR4, 328MHz
BW=32 Col=10 Bk=4 BG=2 CS0 Row=16 CS=1 Die BW=16 Size=2048MB
change to: 328MHz
change to: 528MHz
change to: 784MHz
change to: 924MHz(final freq)
out
U-Boot SPL board init
U-Boot SPL 2017.09-g977627f-dirty #pikajian (Sep 23 2025 - 15:24:50)
unknown raw ID phN
unrecognized JEDEC id bytes: 00, 00, 00
Trying to boot from MMC1
Best phase range 57-23 (30 len)
Successfully tuned phase to 225, used 1ms
SPL: A/B-slot: _a, successful: 0, tries-remain: 7
Can not find usable trust
Load trust part failed! ret=-64
## Verified-boot: 0
## Checking optee storage address 0x000045b7 excute address 0x08400000 ... sha256(12addce29b...) + OK
spl_load_kernel_fit: no partition
Trying to boot from MMC2
Card did not respond to voltage select!
mmc_init: -95, time 10
spl: mmc init failed with error: -95
SPL: failed to boot from all boot devices
### ERROR ### Please RESET the board ###
# Reset the board to bootrom #
請問有甚麼方法能救回來嗎?
|
|
收藏
闽公网安备 35010202001061号