rk3568出厂的Debian系统PCIE3.0是x几的？

[复制链接] · 发表于 2022-3-17 16:51:08

rk3568出厂的Debian系统PCIE3.0是x几的？现在我接入一个pcie板卡，能够检测到板卡，但是连接状态位宽是x1，不是x2，导致CPU和板卡通讯速率降低
问一下是什么原因？
这是lspci -vvv查到的信息
      Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B- DisINTx+
      Status: Cap+ 66MHz- UDF- FastB2B- ParErr- DEVSEL=fast >TAbort- <TAbort- <MAbort- >SERR- <PERR- INTx-
      Latency: 0
      Interrupt: pin A routed to IRQ 114
      Region 0: Memory at 380a00000 (64-bit, prefetchable) [size=16K]
      Region 4: Memory at 380900000 (32-bit, non-prefetchable) [size=256K]
      Region 5: Memory at 380940000 (32-bit, non-prefetchable) [size=256K]
      Capabilities: [80] Power Management version 3
            Flags: PMEClk- DSI- D1+ D2- AuxCurrent=0mA PME(D0+,D1+,D2-,D3hot+,D3cold-)
            Status: D0 NoSoftRst+ PME-Enable- DSel=0 DScale=0 PME-
      Capabilities: [90] MSI: Enable- Count=1/1 Maskable+ 64bit+
            Address: 0000000000000000  Data: 0000
            Masking: 00000000  Pending: 00000000
      Capabilities: [b0] MSI-X: Enable+ Count=128 Masked-
            Vector table: BAR=0 offset=00002000
            PBA: BAR=0 offset=00003000
      Capabilities: [c0] Express (v2) Endpoint, MSI 00
            DevCap: MaxPayload 512 bytes, PhantFunc 0, Latency L0s <1us, L1 <1us
                     ExtTag- AttnBtn- AttnInd- PwrInd- RBE+ FLReset+ SlotPowerLimit 0.000W
            DevCtl: Report errors: Correctable+ Non-Fatal+ Fatal+ Unsupported+
                     RlxdOrd+ ExtTag- PhantFunc- AuxPwr- NoSnoop+ FLReset-
                     MaxPayload 128 bytes, MaxReadReq 512 bytes
            DevSta: CorrErr+ UncorrErr- FatalErr- UnsuppReq- AuxPwr- TransPend-
            LnkCap: Port #0, Speed 8GT/s, Width x4, ASPM L0s L1, Exit Latency L0s <256ns, L1 <8us
                     ClockPM+ Surprise- LLActRep- BwNot- ASPMOptComp+
            LnkCtl: ASPM Disabled; RCB 64 bytes Disabled- CommClk-
                     ExtSynch- ClockPM- AutWidDis- BWInt- AutBWInt-
            LnkSta: Speed 8GT/s, Width x1, TrErr- Train- SlotClk- DLActive- BWMgmt- ABWMgmt-
            DevCap2: Completion Timeout: Range B, TimeoutDis+, LTR-, OBFF Via message
            DevCtl2: Completion Timeout: 16ms to 55ms, TimeoutDis-, LTR-, OBFF Disabled
            LnkCtl2: Target Link Speed: 8GT/s, EnterCompliance- SpeedDis-
                     Transmit Margin: Normal Operating Range, EnterModifiedCompliance- ComplianceSOS-
                     Compliance De-emphasis: -6dB
            LnkSta2: Current De-emphasis Level: -6dB, EqualizationComplete+, EqualizationPhase1+
                     EqualizationPhase2+, EqualizationPhase3+, LinkEqualizationRequest-
      Capabilities: [100 v2] Advanced Error Reporting
            UESta:  DLP- SDES- TLP- FCP- CmpltTO- CmpltAbrt- UnxCmplt- RxOF- MalfTLP- ECRC- UnsupReq- ACSViol-
            UEMsk:  DLP- SDES- TLP- FCP- CmpltTO- CmpltAbrt- UnxCmplt- RxOF- MalfTLP- ECRC- UnsupReq- ACSViol-
            UESvrt: DLP+ SDES+ TLP- FCP+ CmpltTO- CmpltAbrt- UnxCmplt- RxOF+ MalfTLP+ ECRC- UnsupReq- ACSViol-
            CESta:  RxErr- BadTLP- BadDLLP- Rollover- Timeout+ NonFatalErr-
            CEMsk:  RxErr- BadTLP- BadDLLP- Rollover- Timeout- NonFatalErr+
            AERCap: First Error Pointer: 00, GenCap+ CGenEn- ChkCap+ ChkEn-
      Capabilities: [140 v1] Alternative Routing-ID Interpretation (ARI)
            ARICap: MFVC- ACS-, Next Function: 0
            ARICtl: MFVC- ACS-, Function Group: 0
      Capabilities: [150 v1] Device Serial Number 00-00-00-00-00-00-00-00
      Capabilities: [160 v1] Power Budgeting <?>
      Capabilities: [200 v1] Single Root I/O Virtualization (SR-IOV)
            IOVCap: Migration-, Interrupt Message Number: 000
            IOVCtl: Enable+ Migration- Interrupt- MSE+ ARIHierarchy-
            IOVSta: Migration-
            Initial VFs: 7, Total VFs: 7, Number of VFs: 7, Function Dependency Link: 00
            VF offset: 1, stride: 1, Device ID: 0212
            Supported Page Size: 00000553, System Page Size: 00000001
            Region 0: Memory at 0000000000000000 (64-bit, non-prefetchable)
            VF Migration: offset: 00000000, BIR: 0
      Capabilities: [300 v1] #19
      Capabilities: [910 v1] #25
      Capabilities: [920 v1] #27
      Capabilities: [9c0 v1] #26
      Kernel driver in use: nvme

只看该作者 · 发表于 2022-3-18 11:23:36

硬件是支持PCIe3.0 x 2，你要确认下你的板子是1xLane还是2xLane的。

只看该作者 · 发表于 2022-3-18 14:07:00

onepiece 发表于 2022-3-18 11:23
硬件是支持PCIe3.0 x 2，你要确认下你的板子是1xLane还是2xLane的。

你好，如何确认我的板子是1xLane还是2xLane的？
我的CPU板型号是TX030D
mainboard类型是35101

只看该作者 · 发表于 2022-4-21 11:44:13

Hi,为什么我的3568的板子，pcie控制器显示的是3566，是不是这个原因导致我的pcie是x1

0002:20:00.0 PCI bridge: Fuzhou Rockchip Electronics Co.,[color=Red] Ltd Device 3566 [/color](rev 01) (prog-if 00 [Normal decode])

        Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR+ FastB2B- DisINTx+

        Status: Cap+ 66MHz- UDF- FastB2B- ParErr- DEVSEL=fast >TAbort- <TAbort- <MAbort- >SERR- <PERR- INTx-

        Latency: 0

        Interrupt: pin A routed to IRQ 115

        Region 0: Memory at <unassigned> (64-bit, non-prefetchable)

        Bus: primary=20, secondary=21, subordinate=21, sec-latency=0

        I/O behind bridge: 0000f000-00000fff

        Memory behind bridge: 80900000-809fffff

        Prefetchable memory behind bridge: 0000000080a00000-0000000080afffff

        Secondary status: 66MHz- FastB2B- ParErr- DEVSEL=fast >TAbort- <TAbort- <MAbort- <SERR- <PERR-

        [virtual] Expansion ROM at 380b00000 [disabled] [size=64K]

        BridgeCtl: Parity- SERR- NoISA- VGA- MAbort- >Reset- FastB2B-

                PriDiscTmr- SecDiscTmr- DiscTmrStat- DiscTmrSERREn-

        Capabilities: [40] Power Management version 3

                Flags: PMEClk- DSI- D1+ D2+ AuxCurrent=375mA PME(D0+,D1+,D2-,D3hot+,D3cold-)

                Status: D0 NoSoftRst+ PME-Enable- DSel=0 DScale=0 PME-

        Capabilities: [50] MSI: Enable+ Count=16/32 Maskable+ 64bit+

                Address: 00000000fd450040  Data: 0000

                Masking: fffffcff  Pending: 00000000

        Capabilities: [70] Express (v2) Root Port (Slot-), MSI 08

                DevCap:        MaxPayload 256 bytes, PhantFunc 0

                        ExtTag- RBE+

                DevCtl:        Report errors: Correctable+ Non-Fatal+ Fatal+ Unsupported+

                        RlxdOrd+ ExtTag- PhantFunc- AuxPwr- NoSnoop-

                        MaxPayload 128 bytes, MaxReadReq 512 bytes

                DevSta:        CorrErr- UncorrErr- FatalErr- UnsuppReq- AuxPwr- TransPend-

                LnkCap:        Port #0, Speed 8GT/s, Width x2, ASPM L1, Exit Latency L0s <4us, L1 <64us

                        ClockPM- Surprise- LLActRep+ BwNot- ASPMOptComp+

                LnkCtl:        ASPM Disabled; RCB 64 bytes Disabled- CommClk-

                        ExtSynch- ClockPM- AutWidDis- BWInt- AutBWInt-

                LnkSta:        Speed 8GT/s, Width x1, TrErr- Train- SlotClk+ DLActive+ BWMgmt- ABWMgmt-

                RootCtl: ErrCorrectable- ErrNon-Fatal- ErrFatal- PMEIntEna+ CRSVisible-

                RootCap: CRSVisible-

                RootSta: PME ReqID 0000, PMEStatus- PMEPending-

                DevCap2: Completion Timeout: Not Supported, TimeoutDis+, LTR+, OBFF Via message/WAKE# ARIFwd-

                DevCtl2: Completion Timeout: 50us to 50ms, TimeoutDis-, LTR+, OBFF Disabled ARIFwd-

                LnkCtl2: Target Link Speed: 8GT/s, EnterCompliance- SpeedDis-

                         Transmit Margin: Normal Operating Range, EnterModifiedCompliance- ComplianceSOS-

                         Compliance De-emphasis: -6dB

                LnkSta2: Current De-emphasis Level: -6dB, EqualizationComplete+, EqualizationPhase1+

                         EqualizationPhase2+, EqualizationPhase3+, LinkEqualizationRequest-

        Capabilities: [b0] MSI-X: Enable- Count=128 Masked-

                Vector table: BAR=4 offset=00020000

                PBA: BAR=4 offset=00028000

        Capabilities: [100 v2] Advanced Error Reporting

                UESta:        DLP- SDES- TLP- FCP- CmpltTO- CmpltAbrt- UnxCmplt- RxOF- MalfTLP- ECRC- UnsupReq- ACSViol-

                UEMsk:        DLP- SDES- TLP- FCP- CmpltTO- CmpltAbrt- UnxCmplt- RxOF- MalfTLP- ECRC- UnsupReq- ACSViol-

                UESvrt:        DLP+ SDES+ TLP- FCP+ CmpltTO- CmpltAbrt- UnxCmplt- RxOF+ MalfTLP+ ECRC- UnsupReq- ACSViol-

                CESta:        RxErr- BadTLP- BadDLLP- Rollover- Timeout- NonFatalErr-

                CEMsk:        RxErr- BadTLP- BadDLLP- Rollover- Timeout- NonFatalErr+

                AERCap:        First Error Pointer: 00, GenCap+ CGenEn- ChkCap+ ChkEn-

        Capabilities: [148 v1] #19

        Capabilities: [160 v1] L1 PM Substates

                L1SubCap: PCI-PM_L1.2+ PCI-PM_L1.1+ ASPM_L1.2+ ASPM_L1.1+ L1_PM_Substates+

                          PortCommonModeRestoreTime=10us PortTPowerOnTime=14us

                L1SubCtl1: PCI-PM_L1.2- PCI-PM_L1.1- ASPM_L1.2- ASPM_L1.1-

                           T_CommonMode=0us LTR1.2_Threshold=0ns

                L1SubCtl2: T_PwrOn=10us

        Capabilities: [1a0 v1] Vendor Specific Information: ID=0002 Rev=4 Len=100 <?>

        Capabilities: [2a0 v1] Vendor Specific Information: ID=0006 Rev=0 Len=018 <?>

        Kernel driver in use: pcieport

复制代码