TB-RK1808S0烧写固件后无法进入Web网页

TB-RK1808S0烧写固件后无法进入Web网页，错误如下图：

但是通过ssh可以登录到计算棒，ping192.168.180.8也可以ping通

能不能提供以下解决方法
或者提供一种不通过Web页面完成工作模式（workmode）切换的方法

万分感谢！

S0不支持客户自行烧写固件。不知道你用什么方法烧进去。私自烧写无法开机的话只能返厂维修。

Use older image version, there is problem with 1.5.2, but 1.4.1 will let you open the web interface

On a related topic, jeffery is there a way to activate maskrom mode for rk1808 stick (without 5 times plugging in and out) ?

I tried burning custom image that I created from the github sdk, and now I cannot activate maskrom mode anymore. Do I have to open the stick and manually click on reset button perhaps?

rakidis 发表于 2021-1-28 20:56
On a related topic, jeffery is there a way to activate maskrom mode for rk1808 stick (without 5 time ...

1808S0 ?
This is very dangerous, because after burning the wrong firmware, you will never be able to boot unless the 1808 case is removed for shorting operation

rakidis 发表于 2021-1-28 20:53
Use older image version, there is problem with 1.5.2, but 1.4.1 will let you open the web interface
...

The web server has been closed by default, it took up too many resouces.

可以在/etc/toybrick.conf 中打开web开关，然后重启

jefferyzhang 发表于 2021-1-29 08:34
1808S0 ?
This is very dangerous, because after burning the wrong firmware, you will never be able ...

Yeah it is dangerous, we found out the hard way unfortunately.

Can you direct me on how to do that "shorting operation" ?
I saw a maskrom pin on the chip, but don't know exactly what to do with it.

Would it be possible if you shared the schematics for the RK1808S0 ai stick? So that we can examine and try to fix the issues we face with.

Since we are located in turkey, it's not conveinent for us to send the product back for repairing, so we would really appreciate it if you could share the schematics.

Sorry，there is only one way let stick into maskrom mode throught 5 times plugging in and out .

If you forcibly open the shell, it may damage the computing stick.